1. #1
    Hi guys , quick one in the code below is the Z safe set ? Its NCStudio so it might look a bit strange ..

    N70G0X0.000Y0.000S15000M3
    N80G0X108.535Y0.000Z16.699
    N90G1X0.000Z-2.435F3000.0
    N100G1X200.000F2400.0
    N110Y2.381

    The problem is its rising 10 mm and I only have 9 - 8 mm before the stop kicks in on the Z axis, I want to set it to say 4 mm to stop this happening.
    Last edited by Fivetide; 20-02-2013 at 06:31 PM.

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson

  2. Z is set to 16.699 in there

  3. #3
    Thanks AdCNC so if I set it to say 000Z05.00 would that work or would it be 000Z5.00 ?

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson

  4. Ignore what is in front of the Z thats part of the Y coordinates. And yeah, you don't need put a 0 before the 5 just put 5 or what ever you like. :-)

  5. Btw you can ignore the N80,N90,N100 etc that is at the start of each line, thats just line numbering and its set on yours in increments of 10 this does not have any effect on the g code
    Last edited by AdCNC; 21-02-2013 at 12:31 AM.

  6. #6
    Thanks Ad , just one other question if you have time, can I splice the finishing code under the roughing code as I'm attempting to use the same tool for both to try and speed things up ? I have done some test and the ball nose dose exactly the same job as the end mill bit on the wood i'm using.

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson

  7. Yeh sure buddy

  8. The Following User Says Thank You to AdCNC For This Useful Post:


  9. #8
    Quote Originally Posted by AdCNC View Post
    Yeh sure buddy
    Thanks mate for your answers :)

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson

Similar Threads

  1. Need to slow down a signal due to Safe Torque Off alarm
    By corkcnc in forum General Electronics
    Replies: 0
    Last Post: 04-06-2014, 11:35 PM
  2. Safe Z Speed
    By dudz in forum Artsoft Mach
    Replies: 23
    Last Post: 24-05-2014, 04:08 PM
  3. Cambium Code Web Tools Parametric G-code Generation
    By CambiumMachines in forum Manufacturer News
    Replies: 0
    Last Post: 09-01-2013, 04:56 AM
  4. Safe Z Arghhhhhhhh!! Whats going on!
    By AdCNC in forum Machine Discussion
    Replies: 9
    Last Post: 18-08-2009, 05:15 PM
  5. G Code help
    By moose007 in forum Programmers Corner
    Replies: 4
    Last Post: 22-05-2009, 11:39 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •