. .
  1. #1
    Hi All,
    I have just brought an old but updated 125TCL out of storage and it is running the latest software from Boxford. When I boot it up it keeps showing searching for machine on the VDU, I think it is a chip gone down, does anyone know of a reasonable guy to contact to diagonise the fault.

    Thanks in advance.

  2. #2
    Can't help with problem but I've just stripped out all the boxford internals for a Mach3 conversion using modern drives and it was working fine so if you need any parts I have some going free.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Boxford 125 TCL Searching for machine problem
    By dragon in forum Boxford Lathes
    Replies: 1
    Last Post: 28-12-2014, 09:27 PM
  2. VFD error
    By routercnc in forum Spindles & Drive Motors
    Replies: 37
    Last Post: 21-06-2014, 08:40 PM
  3. huanyang vfd 2.2 error E.CO.A
    By edgas10 in forum General Electronics
    Replies: 0
    Last Post: 01-07-2012, 08:12 PM
  4. Solidcam error
    By Kai in forum Solidworks
    Replies: 5
    Last Post: 10-05-2011, 03:41 PM
  5. NEW MEMBER: job searching
    By aaron in forum New Member Introductions
    Replies: 1
    Last Post: 17-02-2010, 02:35 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •