. .
Page 2 of 2 FirstFirst 12
  1. #11
    Sometimes you have to invert the pins for one of the motors if you use two on X, you can tell this if the motors go in opposite directions. Without checking there should be a pin for charge pump? would need to go and check my setup? if you need it then you can not test in the config wizard if i remember rightly. Somebody correct me if i'm wrong?
    If the nagging gets really bad......Get a bigger shed:naughty:

  2. #12
    Pin 1 is the charge pump (enable). Swarfing is correct, the "test axis" buttons in the config wizard don't work if your BOB needs the charge pump signal, however you can test in the software itself. HINT: you need to click the "power on" button and "toggle e-stop" in the software before you can run gcode. Then you can test each axis in the software using either the jog functions, entering gcode manually into the MDI tab or by importing and running a gcode file.

    Longer term, I'd suggest you install DraftSight CAD and dxf2gcode. Then you can quickly create drawings, save them as dxf and then run the dxf2gcode program to create gcode. There are probably better ways to do that, but I'm also a LinuxCNC newby and that is the easiest way I've found so far...

  3. #13
    Thanks chaps.
    I'm only using 3 motors as it will be a light weight system for plasma.
    Currently motors are not mounted - I was just hoping for movement!!
    If the test bit does not work I'll have to move on a little further and see if I can get it to run a simple bit of code. Cheers,

    Danny

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Problem with Zapp Automation website
    By Shinobiwan in forum Marketplace Discussion
    Replies: 17
    Last Post: 26-05-2014, 09:26 AM
  2. Zapp 3-Axis kit - putting it all together
    By birchy in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 18-02-2013, 12:05 PM
  3. Zapp Automation CNC Driver Kit 4 Axis
    By whensparksfly in forum Motor Drivers & Controllers
    Replies: 7
    Last Post: 01-03-2012, 01:54 PM
  4. 10% Discount weekend At Zapp Automation
    By Gary in forum Marketplace Discussion
    Replies: 10
    Last Post: 19-02-2012, 12:42 PM
  5. Zapp Automation Discount Weekend !
    By Gary in forum Manufacturer News
    Replies: 6
    Last Post: 21-08-2011, 11:29 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •