Page 1 of 2 12 LastLast
  1. #1
    Some while ago we had a conversation on the Chinese 4 pin plugs and sockets.
    The type usually sold are not suitable for voltages over 48 volts as they have male pins on the bulkhead sockets.

    Golden Bollocks [ aka Jonathan ] came up with an alternative, I ordered a few and can't find the bastard things.

    Link to the thread or seller please ?
    John S -

  2. #2
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

  3. #3
    Loads of dead links or the male fittings, can't even find the email but it might have been thru ebay and not trawling thru 100's of pages.

    Anyone got a link to 4 pin female bulkhead sockets ?
    John S -

  4. #4
    Regarding the Chinese plugs, is it possible to remove the pins for soldering?

    Thanks

  5. #5
    John just in case you get desperate again. These are microphone plugs, i have tons from old radios and chassis here. But local?

    Mic Plugs/Connectors | THUNDERPOLE.co.uk
    If the nagging gets really bad......Get a bigger shed:naughty:

  6. #6
    Thanks for the link but fired off another email to China, searched high and low and can't find the ones I bought ? but thinking about it now I might not have ordered them after all.

    Still need the reversed sockets to the ones shown, it's illegal to use these on commercial equipment at greater than 30 v DC

    I know it doesn't really apply as XY and Z are always connected but the A axis is mainly left unconnected and any stray chips can easily short the drivers out.

    Remember I'm working on commercial metal cutting equipment and need to follow wiring regs.
    John S -

  7. #7
    Farnell do the mic plug format , can`t place link at moment.

    Bulgin Mini Bucaneer are IP and voltage rated.

  8. #8
    You used to be able to get a flip lid case for them at one time to keep dirt out. Don't know if they changes things or not? they spun as yo tightened them up as not to interfere with the locking ring.
    If the nagging gets really bad......Get a bigger shed:naughty:

  9. #9

  10. #10
    Any ideas where to get the flanged type 4 pole :- Click image for larger version. 

Name:	flange.jpg 
Views:	132 
Size:	18.0 KB 
ID:	8637 approx 25mm square or a plug to fit it ( non screw just locking ring )

    Thanks

Page 1 of 2 12 LastLast

Similar Threads

  1. FOR SALE: 1.5kw chinese spindle with VFD
    By discodave in forum Items For Sale
    Replies: 0
    Last Post: 17-06-2014, 07:05 PM
  2. WANTED: 2.2 KW Chinese Spindle
    By Chaz in forum Items Wanted
    Replies: 2
    Last Post: 17-06-2013, 10:03 AM
  3. WANTED: Chinese 1.5kw spindle/vfd
    By Philly in forum Items Wanted
    Replies: 5
    Last Post: 10-02-2013, 11:44 AM
  4. Multi wire plugs
    By Ricardoco in forum General Electronics
    Replies: 5
    Last Post: 26-11-2012, 01:47 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •