tb6560

**uppy121** · 07-04-2013

hi
what do the folks on this site think of the 4 axis tb6560 motor driver

**Ricardoco** · 07-04-2013

Originally Posted by uppy121

hi
what do the folks on this site think of the 4 axis tb6560 motor driver

Here are a couple of threads that will give the general idea...
http://www.mycncuk.com/forums/motor-...er-boards.html

http://www.mycncuk.com/forums/motor-...ay-update.html

I Suspect there will be a few people using them who have no problems, but i understand they dont like to be pushed, it that is the word..

Rick

**John S** · 07-04-2013

In a short reply - Crap

**Ricardoco** · 07-04-2013

Originally Posted by John S

In a short reply - Crap

John!!

I was trying to be polite

Rick

**uppy121** · 07-04-2013

hi
what else can i use

**John S** · 07-04-2013

CNC Micro-Stepping Stepper Motor Driver 2M542 Bi-polar 2phase 4.2A Switch | eBay

**Carlb1058** · 07-04-2013

Originally Posted by John S

CNC Micro-Stepping Stepper Motor Driver 2M542 Bi-polar 2phase 4.2A Switch | eBay

Her who must be obeyed has given me permission to buy three of 2M542's and the board that goes with 'em although I've noticed 542H - emailed the seller as to what the H is but no response yet, if I don't get one within the next few days I'll just grab the 542's as the price difference is an additional 60+/- a bit quid all up. . .

Addon Bit: Found out the difference, the 542 has a typical supply voltage of +36, whereas the 542H has a +50

**Swarfing** · 08-04-2013

Carl

I run my 542's (or 2m542, same spec) at 42v the 'H's can run at slightly more current i believe (4.5). For your set up the standard 542's will be fine, ignore the +50 bit as well. 50v is really max for these drivers.