I've got mach3 installed & connected to the machine with all the axis moving the amount they are suppose to (thanks John & others that posted).
Was trying to get a bit further yesterday & having watched the first few video tutorials thought I would sort out the homing.
Don't have any switches connected at the moment as the original ones were broken & I am trying to source the same ones but had read that you could set soft limits without switches.
Set the soft limits in the configuration section with a soft max of 750 for x soft min 0. for y soft max 1250 min 0 & for z soft max 0 min -100. Saved the configuration exited mach3 & started up again expecting to see the table extremities when I selected table display but the screen is blank.
Had a look through all the configuration stuff to see if I had missed anything but can't seem to get the table display to show anything, had a look on the mach forum but couldn't seem to find an answer so what am I doing wrong please???