. .

Thread: tiny

  1. #1
    tiny's Avatar
    Lives in , United Kingdom. Last Activity: 08-05-2013 Has been a member for 8-9 years. Has a total post count of 3.
    hi to all,

    l'm an old bloke who has only been into cnc work a little while, needing a hobby now that l have retired from the catering trade. l started by building my own machine and then sold it because it was to big.
    it was a very succesful build and l sold it on ebay for 3k.

    l now have a chinese model and have had some considerable success over the last 6 months turning out som good 3d work.
    l am operating mach 3 and vectric aspire which up to now l have found fairly simple but suddenly l have a problem that l dont understand and hope someone on here can help.
    when l set up a 3d job vectric sends the g code to mach 3 fine but when l start cutting, the cut goes way beyond the parameters l have set and when the tool returns to home for the second cut it stops short of the home point by as much as it over cut on the first cut. could anyone give me a reason for this and a solution.

    thanks a lot, tiny.

  2. #2
    Hi Tiny welcome to the forum, maybe worth starting this thread in the correct area.

    Paul
    If the nagging gets really bad......Get a bigger shed:naughty:

  3. #3
    tiny's Avatar
    Lives in , United Kingdom. Last Activity: 08-05-2013 Has been a member for 8-9 years. Has a total post count of 3.
    hiya paul,
    how do l get it to where it should be

    john

  4. #4
    Pop it in the 'Facts problems and solutions' section

    http://www.mycncuk.com/forums/faqs-problems-solutions/
    Last edited by Swarfing; 02-05-2013 at 10:17 PM.
    If the nagging gets really bad......Get a bigger shed:naughty:

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 11
    Last Post: 01-06-2014, 04:40 PM
  2. WANTED: Need a tiny bit of work done on lathe
    By Tenson in forum Items Wanted
    Replies: 4
    Last Post: 28-02-2013, 12:22 AM
  3. Purelogic Tiny Mach3 USB motion controller PLCM-LPT2
    By Purelogic R&D in forum Manufacturer News
    Replies: 5
    Last Post: 21-08-2012, 08:22 AM
  4. Tiny tool feedrates
    By Robin Hewitt in forum General Discussion
    Replies: 7
    Last Post: 08-09-2010, 02:48 PM
  5. This tiny keyboard might come in handy :)
    By Smiler in forum Gantry/Router Machines & Building
    Replies: 0
    Last Post: 28-12-2009, 06:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •