Question on PCB and routing

[Fivetide]

I normally include an electrolytic cap on the output of linear regulators, then add a ceramic near the input of anything that may be affected by noise.

Although things may work without caps on the linear regs, it's not good practise. Lots of linear regulators specify minimum capacitence on the output lines in their datasheets.

Hi MC , I'm more than happy to take your advice on this, what should I include and where .. Remember I'm a total Noob and I'm just following someone schematic. I have some CFR50 carbon film resistor,10K 0.5W will these do ?