1. #1
    Hi All, Ive just been gifted a Sepro MPA-II V2 Robot,mine is the Electric Version as opposed to the Air/Pneumatic.
    This is the Link to the Site:-
    Sepro Sprue Pickers & Pick and Place Robots for Injection Moulding Machines - Tepro

    I dont have the pendant, my control panel is the Lower one.

    Its in bits but was working when crated, my question is, does anybody know how i can find the maximum speed of the monster servo motor that comes with it.. all the information i have is as follows.

    Infranor Drive With
    Brushless Servo Motor
    24V-12Nm
    22A
    VR-24V
    Model: LD640EGA2300
    There are a few other numbers but i cant make any sence of them

    Rick
    Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln

  2. #2
    Don't know anything about robots, but WOW what a gift!! Good luck with it Rick. G.

  3. #3
    If the nagging gets really bad......Get a bigger shed:naughty:

  4. #4
    Quote Originally Posted by Swarfing View Post
    OMG I searched for hours before i came and posted that, Thanks very Much...

    So next question will be....Spindle???? with pulleys???? Yes---No??

    Rick

    Hey GEOFFREY.. yes what a gift, but then they dont come without cultivation and a few sacrifices on my part i can tell you LOL...
    Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln

  5. #5
    No worries Rick, big question is though what are your plans for it? what sort of size is it?
    If the nagging gets really bad......Get a bigger shed:naughty:

  6. #6
    Quote Originally Posted by Swarfing View Post
    No worries Rick, big question is though what are your plans for it? what sort of size is it?
    Well the shaft is a little under an inch by the looks of things although ive not uncrated it to have an accurate measure i reckon the motor is over 10 inches long....if i can i would like to use it as a motor to drive a spindle, not even sure that is possible... but here is hoping LOL

    Rick
    Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln

Similar Threads

  1. Replies: 2
    Last Post: 23-04-2014, 03:14 PM
  2. Motor identification help
    By Clive S in forum Stepper & Servo Motors
    Replies: 3
    Last Post: 25-09-2013, 06:35 PM
  3. PARAJUST VFD part identification
    By asto in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 28-04-2013, 10:08 PM
  4. Machine Identification - What Is This?
    By machineage in forum Milling Machines, Builds & Conversions
    Replies: 9
    Last Post: 18-02-2013, 01:36 AM
  5. servo motor as spindle motor
    By Scott in forum General Discussion
    Replies: 1
    Last Post: 03-10-2010, 06:42 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •