1. #1
    Where can I find something like this in the UK for Alu milling?

    Spra-Kool Midget Mist Coolant Spray Unit & Coolant - LittleMachineShop.com

    Thanks

  2. #2
    How about making one yourself :-)

    one of these
    High Capacity Water Filter Kit 10" | Screwfix.com

    And one of these at the bottom of the page
    Misting Systems, Water Sprinklers, & Mist and Irrigation Supplies from ACF Greenhouses

    You can get the misting ends in singles from the UK. Go visit a garden centre and have a look at what you can get for a few quid rather than the fortune for a special one for the mill or lathe.

    PS

    You can get away with using a aquarium high volume air supply unit for the mix and pressurize the container
    Last edited by Swarfing; 24-06-2013 at 10:03 PM.
    If the nagging gets really bad......Get a bigger shed:naughty:

  3. #3
    Quote Originally Posted by Swarfing View Post
    How about making one yourself :-)

    one of these
    High Capacity Water Filter Kit 10" | Screwfix.com

    And one of these at the bottom of the page
    Misting Systems, Water Sprinklers, & Mist and Irrigation Supplies from ACF Greenhouses

    You can get the misting ends in singles from the UK. Go visit a garden centre and have a look at what you can get for a few quid rather than the fortune for a special one for the mill or lathe.

    PS

    You can get away with using a aquarium high volume air supply unit for the mix and pressurize the container
    Thanks.

    I did actually buy a high pressure acquaruim pump but found it lacking for general air pressure - I still have it and my newly acquired compressor ... will look at options - thanks.

  4. #4
    It's quite surprising what you can get out of those cheap tyre inflators. Connect theme to a small gas bottle and you have constant pressure. This worked great for an airbrush project i did years ago, cooling was an issue on the first model i did.
    If the nagging gets really bad......Get a bigger shed:naughty:

  5. #5

Similar Threads

  1. CAM systems
    By Rob Stewart in forum CAD & CAM Software
    Replies: 0
    Last Post: 05-08-2011, 06:24 PM
  2. Hypertherm Plasma Cutting Systems
    By Hypertherm John in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 04-03-2011, 02:46 PM
  3. any one know about auto lube systems?
    By graffian in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 02-03-2009, 05:52 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •