. .
Page 2 of 2 FirstFirst 12
  1. Nope, the resistor has nothing to do with what Mach3 displays.

  2. This is normal if using the PLCM motion controller with mach 3.
    It is because if you hit the limit the controller goes into estop condition and stops talking to mach 3.
    Once you hit the reset switch it will start talking to mach 3 again.
    You may need to jog off the limit though, so you should press "auto limits override" button before reset.

  3. #13
    Thanks Gary for this info, Still not got the servo working will finish all the mechanical work first then will start to send you the screen prints.

    Thanks everyone for all your help.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Proximity switch NPN or PNP
    By Matt81 in forum General Electronics
    Replies: 9
    Last Post: 19-04-2014, 11:38 AM
  2. Spindle position sensor
    By GeoffV in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 23-03-2014, 10:00 PM
  3. How to Wire this Sensor
    By manofgresley in forum General Electronics
    Replies: 1
    Last Post: 26-11-2013, 05:09 PM
  4. Proximity Switches
    By kingcreaky in forum General Electronics
    Replies: 20
    Last Post: 23-10-2013, 01:30 PM
  5. Mdx-40 (with zcl-40) Y sensor bar. Help!
    By Rastamonk77 in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 12-02-2013, 09:44 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •