. .
Page 1 of 2 12 LastLast
  1. #1
    Hi guys i have my machine up and all is great but the problem i have is that i am losing 100mm top and bottom of the cutting area as spindle does not go to the full size of the bed, so i want to redesign the gantry and was looking to know what everyone else has done/recommends, all help greatly appreciated.
    Thanks

  2. #2
    Can you upload photos of how it is now ?
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

  3. #3
    Hi Eddy i will put some up tomorrow to give you an idea wot im working with. Cheers

  4. #4
    Unless you build the gantry sides so they Offset the Gantry back or extend Rails the gantry runs on so the gantry extends beyond the Bed end you can't get away from losing some cutting area. It's just the nature of the beast.!!
    Last edited by JAZZCNC; 02-02-2014 at 08:55 PM.

  5. #5
    Hi Jazz yes i know what you mean thats what im thinking of doing by build a whole new gantry but need a few design ideas.
    Thanks

  6. #6
    Edit: Please ignore this, I've just seen your spindle stops short at both ends so my comment was rubbish.
    Last edited by EddyCurrent; 03-02-2014 at 05:07 AM.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

  7. #7
    Hi guys trin to upload photos but it wont let it keeps asking me to log in and then wont let me log in..

  8. #8
    Hi guys see attached pics to give you an ides of my problem.

  9. #9
    Not great pics but got them up

  10. #10
    Still confused, do you mean at each end of the bed such that the gantry cannot reach to the full extent or each side of the bed such that the Z axis cannot reach the full extent ?
    The side of the bed being the longest dimension.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. BUILD LOG: 5'x3' Ideas and build.
    By Wal in forum DIY Router Build Logs
    Replies: 17
    Last Post: 29-12-2012, 02:03 AM
  2. New machine Ideas
    By jcb121 in forum Gantry/Router Machines & Building
    Replies: 1
    Last Post: 19-09-2012, 10:18 AM
  3. Need some ideas
    By jpcnc in forum Machine Discussion
    Replies: 20
    Last Post: 29-01-2011, 07:56 PM
  4. Ideas and inspiration....?
    By Tom in forum General Discussion
    Replies: 20
    Last Post: 10-08-2010, 01:09 AM
  5. Any ideas on the best use of this????
    By Ross77 in forum Gantry/Router Machines & Building
    Replies: 8
    Last Post: 01-08-2010, 11:41 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •