Hi newbie looking for advice

[njhussey]

Hi thanks for the advice, the router is to start off with just for me to get use to router/software as time goes by i hope to improve/modify ill will be only cutting MDF / ply and speed isn't a issue,

thanks mark

No problems Mark, get a design drawn up for everyone to look at (it's surprising the little things you don't think about that others who've done it before know about) and take it from there. Don't buy anything until you've got your design finalised, especially the electronics, as things can change quite alot...

P.s. unfortunately you need speed to cut wood....unless you've a slow spindle.