Thread: Advice on spindle inverter spec
Threaded View
-
14-09-2013 #1
Hi all,
I could do with some advice on the next phase in my quest to reinstate the ISEL CNC machines - the spindles. Without going into all the details - I bought a job lot of equipment, some of it works, some have needed work and all of it has needed a lot of research. So, the problem. . . . . .
Attached are two plaques which can be found on the two spindles in question. Here is a picture of one so that you don't have to imagine.
This one:
4200 rpm
75hz
0.65kw
This one :
24000 rpm
300hz
0.55 kw
The latter spindle works great with this KEB F5 1.5kw inverter - so I can only assume that it was the intended inverter for the spindle and was separated at some point.
So, the first one needs an inverter. Based on the information above and in each image, can you advise on an appropriate inverter for the job? Is it as simple as getting a 1.5kw inverter from ebay (based on the motor's KW rating being slightly more than the other motor) or have a grossly underestimated the situation!!
Any input would be greatly appreciated.
Chris
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Confirming PSU spec for steppers.
By Rogue in forum Stepper & Servo MotorsReplies: 103Last Post: 13-01-2014, 12:37 AM -
50/60 volt spindle inverter.
By GEOFFREY in forum Spindles & Drive MotorsReplies: 0Last Post: 24-12-2012, 03:58 PM -
Water cooled chinese spindle collets, Advice from owners please
By craigrobbo in forum Generic Chinese SpindlesReplies: 15Last Post: 11-05-2012, 12:08 PM -
FOR SALE: 2.2KW Water Cooled Spindle + Inverter (yes the Chinese one!)
By Bokoshoko in forum Items For SaleReplies: 3Last Post: 06-02-2012, 12:43 PM -
System spec and Mach3
By gorbo in forum Computer HardwareReplies: 5Last Post: 23-01-2011, 03:25 PM
Bookmarks