Thread: Driver & Driven
Threaded View
-
15-09-2013 #1
Hi
I should know the answer to this, and i think i do, i just need reassuring.
I have a 3Nm, Nema 23 motor, i am going to use to power my Z axis on my milling machine, i intend to use a toothed belt & pulleys, my question is this, should the DRIVER pully (ie, attached to motor shaft) be LARGER or SMALLER the the pulley being DRIVEN (ie attached to Z axis Leadscrew)
Regards
Ray
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
stepper motors not being driven
By sprint in forum Machine Control SoftwareReplies: 4Last Post: 12-02-2013, 03:42 AM -
2 Motors driven from one driver in parallel
By fozziebear40 in forum Motor Drivers & ControllersReplies: 5Last Post: 12-07-2012, 09:22 AM -
NEW MEMBER: marker pen driven over an 8x4 sheet help.
By Danny in forum New Member IntroductionsReplies: 40Last Post: 02-12-2011, 12:45 AM -
BUILD LOG: 8020 belt driven 3 axis
By compfranon in forum DIY Router Build LogsReplies: 20Last Post: 30-03-2010, 05:06 PM -
BUILD LOG: Belt driven 3 axis machine
By Swarfing in forum DIY Router Build LogsReplies: 14Last Post: 21-02-2010, 10:46 PM
Bookmarks