1. #1
    Hello, sorry im being a bit of a pain during this CNC conversion. But I am learning a lot. Especially on the wiring side of things.



    I hope this will be my final saga in the EMCO Conversion. I have the machines 2 axis moving fine now. All that remains is the Spindle control.



    I bought the C6 board as advised on a previous thread. But I cant seem to figure out how to wire this in. I am using a HG07 break out board from CNC4YOU.



    Could someone please advise me on how to set up the spindle control using these devices. I feel I could be missing a piece of the jigsaw.



    Cheers,



    Pete

  2. #2
    Pete,

    Does this thread explain it enough ?

    http://www.mycncuk.com/forums/router...ter-mach3.html

Similar Threads

  1. Emco C5 spindle motor control
    By GeoffV in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 19-03-2014, 04:20 PM
  2. PCPPS B.O.B. - OK for spindle control?
    By birchy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 09-09-2013, 12:50 AM
  3. Spindle Speed Control
    By cncJim in forum Spindles & Drive Motors
    Replies: 15
    Last Post: 18-06-2013, 07:53 PM
  4. Help with spindle control
    By wizzy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 12-02-2011, 12:51 AM
  5. CNC spindle control VFD problem
    By djc in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 13-09-2009, 09:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •