1. #1
    Hi Guys,

    I have a lovely little Denford Triac VMC with atc. I think I should have VR milling software version 2.31 but am thinking of trying to get the machine to a point where it could use Mach 3.
    My question to anybody that knows about such matters is is the upgrade to Mach 3 worth a lot of time hassle and money? If so some pointers as to why may help me make the right decision.

    Further info

    If anyone knows how to upgrade my machine or has done so using off the shelf or custom parts any help would be great. I would pay for the right help and am on the south coast if there is someone local that would like a project to help with.

    I have little knowledge but believe the Mach 3 need more I/O ports to interface correctly

    Many thanks for any help that anyone can offer.

    Best regards


  2. #2
    Last edited by EddyCurrent; 17-11-2013 at 10:44 PM.

  3. The Following User Says Thank You to EddyCurrent For This Useful Post:

  4. #3
    Yes Eddy thank you very much but had read this one. I had better not strip mine down in my bedroom or I would be for the high jump!

    Many thanks


Similar Threads

  1. A good price?
    By Philly in forum Marketplace Discussion
    Replies: 7
    Last Post: 17-04-2013, 10:03 PM
  2. NEW MEMBER: Good aft one and all...
    By Swarf in forum New Member Introductions
    Replies: 1
    Last Post: 22-04-2012, 06:03 PM
  3. NEW MEMBER: Good day all!
    By icedfusion in forum New Member Introductions
    Replies: 0
    Last Post: 07-10-2011, 07:38 PM
  4. is this kit any good
    By deannos in forum General Electronics
    Replies: 6
    Last Post: 26-03-2011, 08:17 AM
  5. NEW MEMBER: Good Day All
    By Mad Professor in forum New Member Introductions
    Replies: 3
    Last Post: 07-06-2009, 09:13 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts