Thread: back again..... new member
Threaded View
-
29-11-2013 #11
Don't think so Geoff pretty sure they are for plunge drilling. If you look close you can see 3 sets of linear rails, each spindle has it's own back plate and each connected to a cylinder and 1 wide rail each and the Whole Z axis has another set of rails that move both together.
Also the Left Drilling spindle is fixed but the right can be offset using the Slots in the back plate, the Bar running horizontal acts has a register.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Getting back into it...
By mozzbo in forum New Member IntroductionsReplies: 0Last Post: 30-04-2014, 08:47 PM -
NEW MEMBER: New Member Back again : )
By az786again in forum New Member IntroductionsReplies: 3Last Post: 05-03-2014, 11:36 AM -
angular contact bearings - back to back, further apart
By dsc in forum Linear & Rotary MotionReplies: 16Last Post: 05-01-2014, 10:59 PM -
Hi All, I'm back!
By irving2008 in forum General DiscussionReplies: 6Last Post: 11-04-2012, 10:01 PM -
NEW MEMBER: back in the saddle
By abos in forum New Member IntroductionsReplies: 0Last Post: 24-07-2009, 09:21 PM
Bookmarks