I'm in London looking for a machine to engrave our aluminium faceplates, the engraving needs to be about 0.3mm deep and is from a DXF file, the units are 110mm x 110mm. Looking around I think a Roland or Gravograph might do the job? but I'm sure you will know better than me what I could use/ should use? Any suggestions welcome.
See pic for roughly what we need to do, the letters are about 8mm high.
If you have a suitable "pre loved" unit let me know :-)
Last edited by stuboy; 05-12-2013 at 06:28 PM.
By SHAH in forum Classified Ads, Buy, Sell & SwapReplies: 4Last Post: 08-07-2015, 10:28 AM
By Mad Professor in forum Metal Finishing TechniquesReplies: 2Last Post: 04-05-2013, 10:02 PM
By Nathan_Partington in forum Computer SoftwareReplies: 4Last Post: 17-05-2012, 12:49 PM
By soyeb in forum General DiscussionReplies: 2Last Post: 30-05-2011, 10:51 AM
By diy-john in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 09-03-2011, 12:24 PM