. .
Page 2 of 2 FirstFirst 12
  1. #11
    I managed to get it all connected up again today, the drive trips on fault F1009 when I switch to vector mode, remember it works great in v/f mode.

    Check parameter settings. Following
    must apply for induction motor:
    • 1 < (60 · 9907 MOTOR NOM FREQ / 9908 MOTOR NOM SPEED) < 16
    • 0.8 < 9908 MOTOR NOM SPEED / (120 · 9907 MOTOR NOM FREQ / Motor poles) < 0.992


    So point 1.
    motor freq = 400
    motor speed=24000
    60 x 400 / 24000 = 1
    well it says it should be greater than 1 and less than 16

    point 2.
    motor poles = 2
    24000 / ((120 x 400)/num poles)) = 1
    it says it should be greater than 0.8 and less than 0.992 so that's why it's going into fault.

    I changed the nominal speed to 23760 and that solved the problem.

    Now though it trips on over-current but I'd had enough today, and yes I do have the correct figures in for nominal current it's 9.5 Amps and max current is set to 17.6 Amps
    Last edited by EddyCurrent; 29-12-2013 at 09:47 PM.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: new member building a cnc router
    By steeplejack in forum New Member Introductions
    Replies: 1
    Last Post: 11-10-2017, 05:07 AM
  2. Help on building an enclosure
    By thomashomer1986 in forum General Electronics
    Replies: 12
    Last Post: 02-02-2014, 06:38 PM
  3. NEW MEMBER: CNC and other Machine Building Berlin
    By Andikid in forum New Member Introductions
    Replies: 1
    Last Post: 07-10-2010, 11:30 PM
  4. NEW MEMBER: Started building!
    By bobgrant in forum New Member Introductions
    Replies: 1
    Last Post: 02-09-2010, 09:42 AM
  5. BUILD LOG: Building a mechmate here in the u.k
    By kingfisher in forum DIY Router Build Logs
    Replies: 1
    Last Post: 30-01-2010, 02:13 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •