. .
  1. #1
    As the title DIYCNC version 2 board does anybody have a manual please?
    ..Clive
    The more you know, The better you know, How little you know

  2. #2
    I looked back through their website's various incarnations and couldn't find a Version 2 board

    https://web.archive.org/web/*/www.DIYCNC.co.uk
    You think that's too expensive? You're not a Model Engineer are you? :D

  3. #3
    Quote Originally Posted by magicniner View Post
    I looked back through their website's various incarnations and couldn't find a Version 2 board

    https://web.archive.org/web/*/www.DIYCNC.co.uk
    Yes thanks I had checked that. I am using this as an experiment because it can accept at 15-70 V and then give out 12V and 5V with its built in regs. I am also using one of those crap Chinese bobs to drive a mill with 3 mpg's and separate homing on each axis. with Linuxcnc. The crap board needs 12-24V plus 5V. I will then have 10 inputs 6 for the mpg's and 3 for the homing etc.
    Last edited by Clive S; 10-03-2018 at 10:32 AM.
    ..Clive
    The more you know, The better you know, How little you know

  4. #4
    So if it didn't feature anywhere on DIYCNC's site is it one of the currently available Chinese boards?
    You think that's too expensive? You're not a Model Engineer are you? :D

  5. #5
    Quote Originally Posted by magicniner View Post
    I looked back through their website's various incarnations and couldn't find a Version 2 board

    https://web.archive.org/web/*/www.DIYCNC.co.uk
    That's because It's actually an Opto V3.? Roy only supplied V2 for a very short time but this board Clive as is V3, even thou marked v2. The reason I know is that I gave it to him.

  6. #6
    Quote Originally Posted by JAZZCNC View Post
    That's because It's actually an Opto V3.? Roy only supplied V2 for a very short time but this board Clive as is V3, even thou marked v2. The reason I know is that I gave it to him.
    Thanks for the manual Dean
    ..Clive
    The more you know, The better you know, How little you know

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. What happened to DIYCNC.co.uk ?
    By RocketBoy in forum General Electronics
    Replies: 4
    Last Post: 23-05-2017, 08:14 PM
  2. Roy's DIYCNC System 3 board
    By John S in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 24-03-2017, 12:50 PM
  3. Replies: 0
    Last Post: 13-02-2014, 07:09 PM
  4. Nice one Roy at DIYCNC
    By routercnc in forum Motor Drivers & Controllers
    Replies: 9
    Last Post: 26-10-2010, 02:31 PM
  5. Wiring in power and E-stop on DIYCNC Board
    By m.marino in forum General Electronics
    Replies: 2
    Last Post: 10-05-2009, 10:15 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •