Thread: Ports and pins help ? mach 3
Hey everyone need a bit of help.
I started setting up my heiz in mach3, i came to move the x axis and suddenly the control box started smoking and stopped working ! Heiz have replaced the box.
However i think i may have made a mistake in the port's and pins config. Would anyone help me out, from the following diagrams? Heiz don't make it too clear.
These are the only diagrams that are supplied.
By deisel in forum Projects, Jobs & RequestsReplies: 7Last Post: 20-01-2015, 02:41 PM
By Sparky in forum Artsoft MachReplies: 17Last Post: 13-11-2014, 03:00 PM
By Mattbatt in forum Resources & HelpReplies: 0Last Post: 05-04-2013, 09:12 AM
By deisel in forum Projects, Jobs & RequestsReplies: 12Last Post: 11-03-2013, 02:12 PM
By Dan Brown in forum Motor Drivers & ControllersReplies: 2Last Post: 18-01-2010, 05:37 PM