When i press start on my vfd the spindle starts to spin for a second or so them stops with an error code = DL.
can't find out where the problem is, it has been working fine for months.
Any ideas would be great
P.S it's a 1.5kw with 800w spindle.
The error code doesn't appear to match anything from my Siemens, Mitsubishi, Omron or ABB drive manuals,
Read this Help Please: Huanyang VFD + 1.5Kw Water cooled spindle [Archive] - Woodwork Forums then check the wiring to your spindle motor, especially the plug. With a resistance meter it should read the same between all three wires U-V, V-W, W-U.Spelling mistakes are not intentional, I only seem to see them some time after I've posted
By routercnc in forum Routers, Spindles & ControllersReplies: 37Last Post: 21-06-2014, 07:40 PM
By motoxy in forum Programmers CornerReplies: 2Last Post: 28-02-2014, 06:51 AM
By humbo3d in forum Routers, Spindles & ControllersReplies: 0Last Post: 06-02-2014, 04:49 PM
By CambiumMachines in forum Manufacturer NewsReplies: 0Last Post: 09-01-2013, 03:56 AM
By Mad Professor in forum Artsoft MachReplies: 34Last Post: 11-06-2012, 01:44 PM