Thread: Plasma tuning speed...
During my excessive 'net trawling for information, I have not seen mention of running a plasma cutter at over 5000mm/min, therefore, is there much point in tuning a small cnc table to speeds of 15-20,000mm/min???
Is it better to tune to say 5000mm/min as a top-end?
By magicniner in forum CAD & CAM SoftwareReplies: 2Last Post: 20-01-2014, 11:57 AM
By Jonathan in forum GCODEReplies: 0Last Post: 07-03-2013, 01:49 AM
By Kevin1970 in forum Artsoft MachReplies: 6Last Post: 13-06-2012, 09:22 PM
By m.marino in forum Stepper & Servo MotorsReplies: 2Last Post: 17-04-2009, 05:55 PM