Thread: Hi Everyone
-
14-03-2014 #1
Hi Everyone, my name is Mike from Lincoln here in the UK and at long last I have joined this forum. Having looked around several forums over the 5-6 months this forum has some very honest and to the point members. I have found the information on here very useful and it's helped me with the design.
I am building my own design of machine with a cutting area of X 55cm Y 75cm Z 18cm for the base frame I've used timber and will use MDF for the cutting bed, having served my time as a chippy many years ago more than I wish to remember now, but being a lover of making things the base was no problem for me.
I hope I can learn from some of the mistakes that I have made in the past and learn not to make them again. I always welcome others advice but don't always use it.
Looking forwards to hearing from you all.
Mike :)
-
15-03-2014 #2
Hi Mike, wellcome to the forum, good luck with your build, I'm sure that you will get lots of help and advice. G.
-
The Following User Says Thank You to GEOFFREY For This Useful Post:
-
16-03-2014 #3
Thanks for the welcome Geoffrey, as for luck I'm going to need loads.
Mike :)
-
18-03-2014 #4
Welcome dude.
hope you will get your prize for which you have joined. :)
-
18-03-2014 #5
Thanks navins, I'm sure I will. lots to read on this forum but it's keeping me away from my build LOL
Mike :)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks