. .
Page 4 of 4 FirstFirst ... 234
  1. #31
    Quote Originally Posted by swisscheese View Post
    The acceleration of x and y is about 110 mm/s^2 and z is about 95.
    Therein lies the problem - the acceleration is just far too low. You want at around 500-1000mm/s^2 on a CNC router, so re-tune your motors to obtain that. You will probably have to reduce the rapid feedrate a little.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

  2. #32
    Whoops my bad sorry got them mixed up. That is the max velocity I mentioned above. The acceleration on all axes is above 700mm/s^2

    I've downloaded mach3 trial and am going to give it a try.

Page 4 of 4 FirstFirst ... 234

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need to slow down a signal due to Safe Torque Off alarm
    By corkcnc in forum General Electronics
    Replies: 0
    Last Post: 04-06-2014, 11:35 PM
  2. Replies: 4
    Last Post: 21-01-2014, 11:00 PM
  3. Help! Steppers losing steps and making a racket under slow feed..
    By fasteddy in forum Stepper & Servo Motors
    Replies: 23
    Last Post: 06-08-2011, 03:03 PM
  4. Forum Slow
    By pcstru in forum General Discussion
    Replies: 3
    Last Post: 27-01-2011, 03:54 PM
  5. stepper speed very slow
    By jonm in forum Stepper & Servo Motors
    Replies: 17
    Last Post: 02-11-2009, 12:39 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •