Thread: Kress Spindle upgrade to a 2kw
Threaded View
-
06-04-2014 #1
Hi people,
I'm about to upgrade my kress spindle to a 2kw or over spindle. I need a 1/2 inch collet so I'm guessing that would be an ER20 ?
ebay as you know has loads of Chinese spindles but is there anything I should be looking for when choosing?
Also any advice on water or air cooled would be great. The least noise the better !
Finally, is there anyway I can control spindle speed from mach 3 ?
Currently switched by the breakout board relay but I wondered if there was a vfd and a control board that talks to each other to make this happen ?
Many thanks
M Pecker
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Improve Kress TIR or get an upgrade?
By Hauk in forum Kress Milling MotorsReplies: 3Last Post: 23-02-2014, 06:18 PM -
eBay: Kress 1050 FME-1 Spindle
By viz in forum Items On eBay UKReplies: 0Last Post: 21-08-2013, 04:04 PM -
Secondary Kress spindle mount.. Does it exist?
By fasteddy in forum Kress Milling MotorsReplies: 6Last Post: 18-08-2010, 05:25 PM -
Aluminium Kress Spindle Holder
By Lee Roberts in forum Metalwork Project ShowcaseReplies: 12Last Post: 16-07-2009, 12:00 AM -
Kress Spindle Holder
By GTJim in forum Kress Milling MotorsReplies: 7Last Post: 25-05-2009, 07:02 PM
Bookmarks