Fitting a pot to a Chinese Spindle VFD

[Clive S]

Not sure if this has been covered. I have just fitted a pot 10K lin part No. 263-3034 from RS. about £1.70 to the space on the clip out display . If this is removed there are 4 screws on the back then you can see the PCB where the pot should be. The pot will fit straight in with no modification's .
.
The VFD has to have the parameters changed PD002 from 0 to 1 and PD070 from 0 to 1 (changes analogue from 0-10 to 0-5) without this the speed only goes up to 12K.
.
I also changed PD011 from 0 to 55 (this sets the lowest speed to 3.3K)

There is a jumper next to the large connecter strip on the right hand side (marked V1/VR) by default this is set to V1 it needs setting to VR so that the pot will function.

I think there is a sticky on the forum somewhere where a list of the general settings are kept could this be updated if its not already done. Hope this is of use to someone. ..Clive