Threaded View
-
23-04-2014 #23
You'll not run this from a Genny. Gennys don't supply a stabel enough power and the Servo's will go bonkers.!
Also I'm no electrics expert but your thinking about Inverters changing voltage is wrong, they can only put out what goes in. So 240 in 240 out, they change phase/frequency not voltage.
Rotary converters will change voltage but they are quite inefficient and you'd need a bloody big bugger for this.!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Advice needed on Amadeal
By croy in forum General DiscussionReplies: 13Last Post: 21-08-2015, 01:28 PM -
bit of advice needed for first mill
By jmac80 in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 06-04-2014, 10:59 PM -
Quick Advice Needed - F&S
By Tenson in forum Tool & Tooling TechnologyReplies: 1Last Post: 01-01-2013, 06:38 PM -
First steps, advice needed
By Wobblycogs in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 02-11-2012, 02:30 PM -
Advice needed for Z Design
By Hobgoblin in forum Linear & Rotary MotionReplies: 8Last Post: 10-09-2012, 09:18 PM
Bookmarks