Thread: Component Check

  1. #1
    I have been converting a Hobby Mill to CNC control, it has taken a while as i have been ill throughout the winter, last week i felt fit enough to start again. I checked the wiring and started the kit up, checking voltages, fuses etc; evrything works but i cannot get the PNOZ safety relay to light up, doea anyone know a way of testing these units on a bench with a voltage regulator?



  2. #2
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

Similar Threads

  1. Do you allow price check threads?
    By dynamis_dk in forum Marketplace Discussion
    Replies: 27
    Last Post: 16-04-2014, 09:07 PM
  2. - Aluminium Profile and Component Supplier
    By KB Aluminium in forum Marketplace Discussion
    Replies: 1
    Last Post: 17-02-2014, 12:52 AM
  3. screening / glitchy operation - sanity check
    By dsc in forum General Electronics
    Replies: 21
    Last Post: 01-12-2013, 10:35 PM
  4. maximum deflection - sanity check
    By dsc in forum Gantry/Router Machines & Building
    Replies: 6
    Last Post: 11-02-2013, 08:33 AM
  5. sanity check - constant running, loads and more
    By dsc in forum Stepper & Servo Motors
    Replies: 4
    Last Post: 26-11-2012, 11:26 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts