. .
  1. 11-05-2014 #1
    nobby's Avatar
    Lives in london, United Kingdom.
    nobby
    Last Activity: 29-06-2023 Has been a member for 9-10 years. Has a total post count of 119.
    H-Bot 3D Printer HB1 dry test No.22 - YouTube

    anyone done that yet?
    with the torch height from a cable
    ????????

    yes, with dual shaft motors, with twin belts top and bottom or single?

    twin bar y axis with turn-buckles each end between them for tensioning.

    does anyone make a idler pulley mount that slots into 45mm t-slot ends

    would you use a single 25mm belt 2525mm long closed loop and get a table about 400mm square

    2525mm divided by 6 -= 420mm square so 600 by 220 or 500 by 320mm

    or would you d twin 15mm pulleys top and bottomso as to not stress the motor shafts so much

    COULD you in fact run 4 motors one in each corner
    Last edited by nobby; 11-05-2014 at 04:17 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 10' x 5' Plasma table design
    By Kerryfisher in forum Plasma Table Machines
    Replies: 4
    Last Post: 20-02-2013, 09:28 AM
  2. NEW MEMBER: Have Built 2 CNC machines 1 mill/drill conversion and 1 Router/plasma from scratch
    By AGB in forum New Member Introductions
    Replies: 3
    Last Post: 06-02-2013, 03:16 AM
  3. RFQ: RFQ: Plasma Table
    By D-man in forum Projects, Jobs & Requests
    Replies: 3
    Last Post: 04-07-2010, 11:08 PM
  4. 3M x 2M Plasma table build
    By MonoNeuron in forum DIY Plasma Build Logs
    Replies: 14
    Last Post: 01-09-2009, 11:11 AM
  5. Plasma table 2m x 1m
    By Robin Hewitt in forum DIY Plasma Build Logs
    Replies: 9
    Last Post: 19-05-2009, 12:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules