Hi Mike
Not had a great deal of time with it yet, just getting used to the software (100 page manual)and put the laser on the network etc.
I haven't checked the beam path alignment yet either.
Then I'll need to make a test file up, to cut at different powers and speeds, to get to know how this machine handles .... apparently, they are all slightly different in personality, and you have to get to know them.
I also need a proper water tank, might need a chiller as the summer comes. Will have to get an air filter for the workshop compressor, so I can ditch the silly little air pump that came with the cutter and run a decent PSI through the air assist ... etc.. etc...
Just Ordered some ally honeycomb to make a bed... lots to do !