-
12-06-2014 #41
Small car radiator and a couple of 120mm 12v fans will do the job I reckon.
-
12-06-2014 #42
-
12-06-2014 #43
remember a freezer is a heat pump ! ... 4x efficient ! :)
-
13-06-2014 #44
Don't let it go above 22 or you will shorten the life of the tube. Get to poundland and buy 2-3 of the aluminium bottles in the camping section. Fill them with water and chuck in the freezer. Use 2 when the water is at 18 and top up as needed.
-
13-06-2014 #45
-
14-06-2014 #46
today is 29deg in the shop (air temp)... ideally I want the laser water at 15-20 deg ... so a radiator at room temp might help, but is not the total solution.
-
14-06-2014 #47
I'm currently looking at used freezers on ebay ,,, seems like £20 is average which seems like a no brainer,
Next thing is coolant.
Laser manual says water and replace every week
I'm thinking car antifreeze ??? what do you think about that ?
Remember , in the winter... temps drop below Z in the work shop !
-
15-06-2014 #48
You want deionised water and some sort of anti freeze that can inhibit corrosion and algae growth etc. I use a chiller and the hpc antifreeze, but will only change my water every 3 months or so
-
15-06-2014 #49
just 'salvaged' the under counter freezer from our kitchen .. It's not been used for about 7 yrs as it cut out some times ... problem was likely lack of ventilation from the sealed run of cabinets and appliances it was housed in ! :/
I plan to fill it with 2L pop bottles filled with water ... as a cold store ... then run a micro bore copper tube (I already have) as sort of a coil ... but to fit where I can ...
I can't see why it wont work ?
Industrial water chillers are plenty £££'s ! ... so I'm hoping to save :) ... hopefully I can use the same set up for my water-cooled spindle too :)
Pics will follow :)
-
13-11-2014 #50
How are you getting on with your laser, I have been thinking again about buying one of these machines?
CNC routing and prototyping services www.cncscotland.co.uk
ADD ME ON FACEBOOKS
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Laser Machine Grounding/Earthing
By Want2build1 in forum Laser Machines & BuildingReplies: 31Last Post: 09-02-2015, 10:18 PM -
Laser Machine Eye protection
By Want2build1 in forum Laser Machines & BuildingReplies: 11Last Post: 19-05-2014, 01:46 PM -
How to save laser machine cost
By Zoe Zhang in forum Manufacturer NewsReplies: 0Last Post: 06-09-2012, 03:41 AM -
Chinese CNC machine modifications - Discussion
By craigrobbo in forum Milling Machines, Builds & ConversionsReplies: 2Last Post: 14-05-2012, 06:51 PM -
WANTED: GCc Laser Pro or Epilog Laser Cutter Machine
By Brownhills school in forum Items WantedReplies: 1Last Post: 10-05-2012, 04:30 PM
Bookmarks