TB6600HG Stepper Motor Driver

[stevep]

Thanks for the further input guys...the stepper driver did not blow at 12volts , 1.2 amps,,,,
it happened as i was using 24 volts and going up through the amp settings....
and yes irving 2008, that is what i am using....and i thought buying big stepper motors was better than buying Nema23/24s and then finding out they did not have the power
Thanks for your advice ...stevep

[JAZZCNC]

...and i thought buying big stepper motors was better than buying Nema23/24s and then finding out they did not have the power
Thanks for your advice ...stevep

Common mistake many people make but you still haven't answerd what your trying to do with them.?

[stevep]

I will be using them to make a cnc wood router....around 2 x 3ft table size
I used the same size to convert my mill drill and raglan lathe to cnc, but I sold these a while back...
Regards,,,,stevep

[JAZZCNC]

I will be using them to make a cnc wood router....around 2 x 3ft table size
I used the same size to convert my mill drill and raglan lathe to cnc, but I sold these a while back...
Regards,,,,stevep

Well sorry to say this but your wasting your time then.! Those drives will never power nema34 motors to give the speed you'll require for a decent router.
Even with nema 23 motors they will struggle to give good reliable performance but with those motors forget it.!