Thread: Driver switching OFF
-
04-06-2014 #11
-
04-06-2014 #12
-
05-06-2014 #13
Hi Jazz
I had i minor wiring fault, i had not stripped the insulation back far enough on one cable therefore there was no contact. Since i corrected this, all 3 of my motors now move, my Z & X axis are ok the drive that did not work yesterday now chatters when i select it on the toggle, i have checked the dip switches, they are set to 4.2 amp, any more ideas?
My Ena + & Ena - were connected, i have disconnected them.Last edited by manofgresley; 05-06-2014 at 12:22 PM.
-
06-06-2014 #14
Hi all.
Many thanks to all you people who have given me advice, my CNC MILL is now "HOMING"
Regards
Ray
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
switching from steppers to servos - STEP / DIR control
By dsc in forum Stepper & Servo MotorsReplies: 6Last Post: 18-06-2014, 12:41 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
FOR SALE: 24v 20 amp ABB switching power supply £90
By gavztheouch in forum Items For SaleReplies: 0Last Post: 07-02-2014, 07:42 PM -
Home switching
By Vard in forum General ElectronicsReplies: 6Last Post: 14-03-2012, 08:32 PM -
Driver box
By John S in forum General ElectronicsReplies: 1Last Post: 21-06-2009, 12:46 PM
Bookmarks