1. #1
    Hi there, does anyone know how to realign the head/spindle on an Easiturn 3? I have one and it runs out quite badly.

    The Denford site is as usual little to no help.

    There's a couple of us wanting to know, so any information would be greatly appreciated.


  2. #2
    hi i had the same problem if you take the small cover that gives access to the spindle off there is a caphead bolt in each corner of the headstock base if you undo them there is a small amount of movement in the headstock that will allow you to move the spindle side to side.
    cheers glen

Similar Threads

  1. denford easiturn
    By scotty in forum General Electronics
    Replies: 8
    Last Post: 27-06-2016, 08:24 PM
  2. Denford ORAC lathe spindle nose upgrade
    By rnr107 in forum Metalwork Project Showcase
    Replies: 17
    Last Post: 01-01-2016, 09:58 AM
  3. RFQ: Spindle for a Denford ORAC
    By rnr107 in forum Projects, Jobs & Requests
    Replies: 0
    Last Post: 07-11-2012, 04:20 PM
  4. Eazicnc on denford easiturn
    By pistolknight in forum Denford Lathes
    Replies: 2
    Last Post: 24-11-2011, 06:55 PM
  5. Denford Triac Spindle Fault
    By Sam_Smith in forum Denford Mills
    Replies: 5
    Last Post: 04-05-2011, 10:07 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts