. .
  1. #1
    Hi there, does anyone know how to realign the head/spindle on an Easiturn 3? I have one and it runs out quite badly.

    The Denford site is as usual little to no help.

    There's a couple of us wanting to know, so any information would be greatly appreciated.

    thanks
    Nemo

  2. #2
    hi i had the same problem if you take the small cover that gives access to the spindle off there is a caphead bolt in each corner of the headstock base if you undo them there is a small amount of movement in the headstock that will allow you to move the spindle side to side.
    cheers glen

  3. #3
    Hi,
    could you please tell me what lubrication is required for the Easiturn 3 i am now rebuilding. I read that Mobil Vactra3 is ok for the centralised lube but what is used for the workhead spindle. It looks like the chuck end of the spindle has a grease nipple but when i removed the spindle bearings there was no evidence of any grease.
    Regards
    Colin

  4. #4
    When i removed my headstock one of the bolts was sheared, so worth checking.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Denford ORAC lathe spindle nose upgrade
    By rnr107 in forum Metalwork Project Showcase
    Replies: 19
    Last Post: 29-04-2019, 07:45 AM
  2. denford easiturn
    By scotty in forum General Electronics
    Replies: 8
    Last Post: 27-06-2016, 09:24 PM
  3. RFQ: Spindle for a Denford ORAC
    By rnr107 in forum Projects, Jobs & Requests
    Replies: 0
    Last Post: 07-11-2012, 05:20 PM
  4. Eazicnc on denford easiturn
    By pistolknight in forum Denford Lathes
    Replies: 2
    Last Post: 24-11-2011, 07:55 PM
  5. Denford Triac Spindle Fault
    By Sam_Smith in forum Denford Mills
    Replies: 5
    Last Post: 04-05-2011, 11:07 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •