1. #1
    Hi, Anyone know where i can source a short length of about 50-100mm of the above at a reasonable price please?

    I have found a 150mm solid bar and then machine out the excess but it'd be nice to need to machine it.

    Last edited by r0bsk1; 10-06-2014 at 09:04 AM.

  2. #2
    I have 140mm x 10mm wall

  3. #3
    Oooh that's so close ill remeasure just in case. How much is it and can you cut to size?

  4. #4
    How much do you need, I can cut but will be with a bandsaw/jigsaw so will not be accurate, you will have to clean up.

    Maybe be possible to part off in my lathe with a bit of jiggery pokey, how accurate do you need
    Last edited by johnsattuk; 11-06-2014 at 08:46 AM.

  5. #5
    Lets say 75mm of tube. This will give me 5mm for cutting and adjustment.
    Last edited by r0bsk1; 12-06-2014 at 01:05 PM.

  6. I hope you meant 75mm lol :)

  7. #7
    Yup i did. edited....

    Think the bike would fall over with 75m stuck to the side of it

  8. #8

    Have dragged it out of my loft where it has been for ~50yrs

    May not be what you want now that I have got it where I can measure it. I guess it is actually 5.5" od with .375 wall ( 149.5 x 9.6 )

    I don't know the spec but it rings quite well and machines OK, it was an off-cut from the switch arms at a large sub-station.

    Click image for larger version. 

Name:	pict0225.JPG 
Views:	90 
Size:	173.2 KB 
ID:	12559

    ~80mm would be 10 in the post.

  9. #9
    Cool its worth a shot for a tenner Paypal ok for you?
    How much of it do you have? I might have the rest if it fits

  10. #10
    PayPal OK, same as my addr. PM your address to send to.

    Got about 240mm left, also have ~450mm x 118 OD x 110 ID. from same source.

Similar Threads

  1. 3mtr CNC pipe profiling machine.
    By D-man in forum Gantry/Router Machines & Building
    Replies: 13
    Last Post: 23-08-2013, 07:49 PM
  2. wall cnc like the wall saw
    By crossleymarko in forum Machine Discussion
    Replies: 10
    Last Post: 25-03-2012, 10:24 AM
  3. wall and floor fixing am I the only one ????????????
    By luke11cnc in forum General Discussion
    Replies: 15
    Last Post: 30-12-2011, 10:45 PM
  4. Pipe thread in 22 tpi???
    By Robin Hewitt in forum Machine Discussion
    Replies: 3
    Last Post: 21-09-2010, 10:19 AM
  5. CNC Wall art from JPG
    By BJ- in forum Opportunities Available & Sought
    Replies: 0
    Last Post: 29-01-2010, 02:06 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts