. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    My first attempt at this question turned into a shapeless ramble, so to be more specific...

    I am aware that there are various tradeoffs around the use of microstepping. In practice, is there any point in going to more than, say, 800 steps/rev?
    Last edited by Neale; 12-06-2014 at 11:19 AM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Advice please! JAF Motion Controller issues!
    By Mark Chard in forum Machine Control Software
    Replies: 0
    Last Post: 31-01-2014, 05:03 PM
  2. CNC Motion control
    By StoneyCNC in forum Manufacturer News
    Replies: 1
    Last Post: 26-08-2013, 10:07 AM
  3. Design issues with linear motion...
    By rob_colby in forum General Discussion
    Replies: 3
    Last Post: 05-01-2011, 12:13 AM
  4. Time for a purpose built motion control computer.
    By GeoffV in forum General Computing
    Replies: 17
    Last Post: 08-11-2010, 01:11 AM
  5. Motion Control drivers and motors
    By bruce_miranda in forum Motor Drivers & Controllers
    Replies: 71
    Last Post: 27-08-2009, 09:40 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •