metalworking pillar drill experiences

[routercnc]

First look at the UCCNC software, and getting some movement . . .

[routercnc]

Finished ! . . . . for now.

[routercnc]

I had some requests for the new control cabinet wiring diagram on my YouTube channel so I'll direct people here (I guess they need to become members to download attachments ?).

While I was building the wiring I noticed a few small errors so hopefully I have remembered them all and corrected them in the diagram, but I can't guarantee it is error free !

By all means use this as a starter or for information, but note it was designed around what I wanted it to do. It is best to have an idea what you are trying to do and ultimately create one yourself. That way if there is a problem, or you want to customise it later, you can make it work.

Obviously there are high voltages used here so if you are not sure, please ask for professional help. Good luck with your project.







Controller upgrade video series starts here:
https://www.youtube.com/watch?v=JCE_Hf0RoFQ&t=135s

[the great waldo]

Hi Routercnc
Thanks very much for that. I'll have a good look through it. It looks like it's going to be a good guide.

Cheers
Andrew

[routercnc]

We are finally back on track - hooray !

Then run straight into a problem - boo !

[routercnc]

Getting the Y axis moving . . .

[routercnc]

Finishing the XY table !

[routercnc]

fitting the DROs . . . .

[routercnc]

Every project gets to a point where you need to make lots of small but necessary parts . . . this is that video !

[routercnc]

Bit of a delay in getting this video sorted out but here we go - rear bellow / covers :