. .
Page 2 of 2 FirstFirst 12
  1. #11
    after posting what i did, anti pulleys and belts.boo. ive gotten a bit more feedback from people who use them.. apparently the GT2 profiles for belts are good and accurate (actually probably more accurate than using the couplings that i have at least)dont know what your setup is. i might well personally give it a go.. will get back with the results when i do.

  2. #12
    I am planning to belt drive my Y-Axis purely because of the space issue. I dont want the motor sticking out that far. I'm not worried about it on the X-Axis though. Hopefully I will get the motor and bearing mount machined today and assembled. I will post some pictures on my build log if I get it done.

    Ian

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. ACME / Trapezoidal leadscrews
    By ZeroCount in forum Lead Screws, Nuts & Supports
    Replies: 8
    Last Post: 08-03-2020, 09:29 AM
  2. Driving me insane
    By Bush Flyer in forum Motor Drivers & Controllers
    Replies: 17
    Last Post: 14-04-2014, 03:55 PM
  3. Restoring old lathes, backlash in leadscrews
    By irving2008 in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 28
    Last Post: 08-09-2009, 12:05 AM
  4. Motors and leadscrews
    By Tom in forum Gantry/Router Machines & Building
    Replies: 10
    Last Post: 29-05-2009, 10:37 PM
  5. Ideas for fitting leadscrews
    By irving2008 in forum Lead Screws, Nuts & Supports
    Replies: 8
    Last Post: 11-11-2008, 10:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •