. .
  1. #1
    Hi All,

    Just an intro and saying Hi.

    Just purchased an Emach (*Please* say I've not cocked up!) EM900 to produce MDF shapes letters and similar.

    Hoping anyone can help out if I need some hand-holding sometime through the forums.

    Thanks in advance guys n gals

  2. #2
    Get some pictures up of it ,or a link to the exact machine ,I cant find any info on them other than a few pissed off customers in the blog below
    http://trickydoubt.blogspot.co.uk/?view=classic.
    maybe if it came at a good price its not all bad and could be improved on.

  3. The Following User Says Thank You to dazza For This Useful Post:


  4. #3
    another emach thread
    http://www.mycncuk.com/threads/5827-...th-new-machine

    I'm sure that if the machine has any problems they can be sorted out here.
    Last edited by EddyCurrent; 17-08-2014 at 01:49 PM.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

  5. The Following User Says Thank You to EddyCurrent For This Useful Post:


  6. #4
    Thanks Eddycurrent... I have seen some comments and this is quite worrying. The machine apparently works and has been used, but to what degree of accuracy I am unsure.
    Its an Em 900 machine built 2006, so perhaps before the rot set in.
    Pics as I have them, I'm hoping it's ready to go, and if needs "Alterations" I can get them done. I'm old school C & G ONC engineer (Machinist style) and can wield a spanner, hammer, gas axe with the best of 'em :-)
    Will post in correct forum a few pics

  7. #5
    Welcome and I hope you have success with your new machine.

    Steve

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Where to start?
    By Inquisitor in forum Gantry/Router Machines & Building
    Replies: 7
    Last Post: 27-11-2012, 02:35 PM
  2. where to start
    By martin54 in forum Gantry/Router Machines & Building
    Replies: 16
    Last Post: 22-09-2012, 11:29 AM
  3. where to start?
    By trounce in forum Gantry/Router Machines & Building
    Replies: 44
    Last Post: 03-10-2011, 02:03 PM
  4. NEW MEMBER: Were do I start?!
    By tonygagey in forum New Member Introductions
    Replies: 4
    Last Post: 07-08-2010, 07:55 PM
  5. Where to start?
    By ricey3 in forum Computer Software
    Replies: 10
    Last Post: 25-10-2009, 08:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •