. .
  1. #1
    dsc's Avatar
    Lives in Lincoln, United Kingdom. Last Activity: 17-06-2020 Has been a member for 9-10 years. Has a total post count of 252. Received thanks 1 times, giving thanks to others 11 times.
    Looking for someone to cut two large pockets in an existing 10mm thick aluminium part (350mm wide and 465mm tall), see attachment, on the left is the existing part and on the right is what I need to cut. The pockets have a 10mm ridge (2mm deep) for the covers to fit flush, I can get the covers done elsewhere, but it's a b*tch to send the large 10mm thick part, so I'm looking for someone local, either down south Surrey (Dorking) or in the Lincoln area (I'll be around next week). This should be a very quick job, so I was thinking of simply showing up with the part, getting the cut done, leaving monies and going home.



    Thanks for looking.

    Regards,
    T.
    Last edited by dsc; 03-10-2014 at 10:13 AM. Reason: dims added, material added

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Quick bit of help
    By amxen in forum General Discussion
    Replies: 9
    Last Post: 29-08-2014, 10:58 PM
  2. NEW MEMBER: Thanks to existing members
    By Lloyd in forum New Member Introductions
    Replies: 1
    Last Post: 05-05-2014, 07:35 AM
  3. Laser cutting 10mm acrylic?
    By camhguh in forum Laser Machines & Building
    Replies: 14
    Last Post: 04-09-2012, 12:51 AM
  4. matching drivers to existing motors
    By 2006Nobull in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 17-07-2012, 08:27 PM
  5. Electronics upgrade for an existing machine.
    By Shinobiwan in forum Electronic Project Building
    Replies: 9
    Last Post: 18-03-2012, 04:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •