Parts needed. Power supply and USB board.

[ukracer]

HI I am a bit wary of posting as I have seen some of the replies on other threads lol.


However I need to get my small CNC engraver working.

When I purchased it second hand it was supposed to have a part missing. Allegedly a power supply but it does seem to have one.

I know its a parallel interface and my computers dont have parallel ports anymore. so I am going to take a photo or two and see if you can assist. bear in mind I only really want it for two things. one to learn how to program and use CNC a bit and 2. To use it on its end to raise and lower a platform about 6 inches or so with a degree of precision.



I forgot to ask where can I get spare parts for these things and can any one tell from the photos what parts are missing. Please bear in mind the controller board is there but I wish to use USB so will need a new board..

regards Andy T