OK guys i may completly be missing the point here but im sure ive seen how to do this, but for the life of me figure it out.

Control box is all wired up perfect by a good friend (AdCNC) however i have had a play so if its withing the box its not his fault!

My table has the following dims:

3mtrs long (X)
1.2mtrs wide (Y)

Now... im running 2 x Nema 34 along the X, motors all run perfect and in the right direction, however when i move the X it shows movement in the Y DRO.!!!

Also when i tune the motors i have to change it in the Y to apply changes to the X

What am i missing here guys