. .
Page 2 of 2 FirstFirst 12
  1. #11
    Thought i had just posted a reply but i must have dicked up.
    make a base plate for the underside support from 10mm plate long enough to be able to clamp to your table, you now want to drill a couple of holes the same dia as your mount securing holes, push in a couple of pins to locate the mount.
    Now drill and tap two holes for the strongback clamping studs, if the holes for these studs are same size as the studiron this will bring the strongback on centre so all you have to do is allign the jig ie mount located and drill in chuck then clamp this to the table so it's undo strongback next please and repeat 50 times.
    Have fun
    Mike

  2. #12
    That'll do it :) thanks.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Re my question
    By oldwoodworker in forum New Member Introductions
    Replies: 32
    Last Post: 20-09-2013, 09:07 PM
  2. PSU question
    By Dwayne Dibbley in forum General Electronics
    Replies: 16
    Last Post: 13-02-2013, 10:15 PM
  3. To usb,or not to usb,that is the question.
    By Jumbo in forum General Discussion
    Replies: 11
    Last Post: 17-10-2011, 09:21 PM
  4. question ...
    By Wobblybootie in forum General Discussion
    Replies: 6
    Last Post: 04-01-2010, 12:04 AM
  5. A question
    By bodgeitandscarper in forum Gantry/Router Machines & Building
    Replies: 7
    Last Post: 02-12-2009, 08:30 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •