1. #1
    I have seen a lot of reference to using double sided sticky tape for holding down wood for routing.

    Are there any preferred makes and suppliers of this please?

    Again sorry for such a newbie question

  2. #2
    I think the last lot I got, my boss got from screw fix and it works fine. Just try any you can find and you will find one that works best for you, like low or high tac. Obviously high tac can be a bit of a pain if using a veneered board as it can pull the grain out and low tac there is the possibility of the piece pinging off. If in doubt use a test piece and start with shallow controlled cuts.

Similar Threads

  1. Double sided tape
    By racerbear02 in forum Woodwork Discussion
    Replies: 4
    Last Post: 22-12-2014, 02:36 PM
  2. Video of CNC machining a double sided part.
    By Shinobiwan in forum Woodworking Project Showcase
    Replies: 26
    Last Post: 17-03-2013, 10:23 AM
  3. Accurate Tape Measure?
    By Tenson in forum Tool & Tooling Technology
    Replies: 19
    Last Post: 26-05-2012, 03:41 PM
  4. FOR SALE: Heidenhain ME101 tape drive
    By pjm in forum Items For Sale
    Replies: 1
    Last Post: 07-08-2011, 01:12 PM
  5. Double sided machining
    By CraftyGeek in forum General Discussion
    Replies: 7
    Last Post: 08-12-2009, 10:04 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts