Thread: help with my cnc build
Threaded View
-
08-02-2015 #1
hi guys
first of all im mainly using it for mdf,plastics and a bit of aluminium, so it will be mostly made of mdf, its based on the metalfusion design
so im looking to use the following
supported linear rails SBR16-300/600/1400mm rails(6 supported rails+12SBR16UU bearing blocks)
3pcs of ballscrews RM1605-300/650/1400mm total length-C7(3screws+3ballnuts+3end-machinings)
3 SETS OF BK/BF12(with locknuts and cir-clips)
3pcs of flexible couplings (6.35mm for the motor shaft)
for the stepper motor drivers i was looking to use these the cnc4you cw5045 would these be ok and what motors and breakout board would you think i would need
thanks for all you help
john
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: a Steel Box Section Build with SBR20 & Ballscrews Plus a few questions
By grain_r in forum DIY Router Build LogsReplies: 130Last Post: 27-01-2023, 06:47 PM -
BUILD LOG: New Build - For Your Amusement - MK-2 build
By Karl in forum DIY Router Build LogsReplies: 12Last Post: 08-02-2017, 08:03 PM
Bookmarks