. .
Page 2 of 2 FirstFirst 12
  1. #11
    Quote Originally Posted by Gary View Post
    The Datasheet is wrong
    Now you look at the datasheet when I have 3 of them sitting on my desk

    I did notice the discrepancies, but I have low expectations of rhyme or reason when looking at stepper specs. May be okay, may be lucky they were cheap

    I'll let you know

    Robin

  2. I dont think you will have any problems, it is just because AU know little about stepper motors, and have not put the correct info on the datasheet.
    Run it in series first at 3A and then try in parallel at 6A, and monitor the temp.

    Quote Originally Posted by Robin Hewitt View Post
    Now you look at the datasheet when I have 3 of them sitting on my desk

    I did notice the discrepancies, but I have low expectations of rhyme or reason when looking at stepper specs. May be okay, may be lucky they were cheap

    I'll let you know

    Robin

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  2. Arc Eurotrade Sieg X2
    By Rogue in forum Marketplace Discussion
    Replies: 12
    Last Post: 01-08-2013, 07:11 PM
  3. Closed Loop Stepper Compared with Open Loop Stepper
    By Leadshine-Erci in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 25-05-2012, 08:11 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •