. .
  1. #1

    Ive had this 4 wire motor lying around for a couple of years, and it bugged me back then. Ive just started to look at dabbling with CNC, this time with the arduino and its bugging me again.

    Has anyone come accross these? I suspect its out of an old printer. The only markings are on the bottom of the case and these are OKI, EM-333 and 0430AT. Ive hunted round on the web and found nothing.

    The wires seem to be 3 grey and 1 blue.

    Advice anyone ? Bin ?


    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	photo0040.jpg 
Views:	496 
Size:	18.5 KB 
ID:	14856   Click image for larger version. 

Name:	photo0041.jpg 
Views:	482 
Size:	18.7 KB 
ID:	14857  

  2. #2
    If you are going to bin it you might as well connect it to a drive with about 24v and see what happens. ..Clive

  3. #3
    Fair point
    Last edited by petejw; 12-03-2015 at 09:54 PM.

  4. #4
    Looks like a motor from an old OKI dot matrix printer from the 80's. Looking at the stamping on the plate i would suspect this is just a two speed motor using different windings? may not be a stepper.
    Last edited by Swarfing; 12-03-2015 at 09:59 PM.
    If the nagging gets really bad......Get a bigger shed:naughty:

  5. The Following User Says Thank You to Swarfing For This Useful Post:

  6. #5
    When you turn the shaft does it feel quite tight and "cog"? If so it's a stepper. Hard to see what else it could be as it's too short to have a commutator. What size is it? If it's 1.4 or 1.7 inch square it's another giveaway. Some of these old small stepper motors are only 48 steps per rev which makes them less useful. Is the cable a ribbon type with a blue strand along one edge? If so it's only to indicate which way round the cable should be connected. With 4 wires it will probably have 2 windings so could be compatible with a modern driver, check them out with a multimeter, there should be 2 pairs, one to each winding and the windings isolated.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 2
    Last Post: 23-04-2014, 02:14 PM
  2. Motor identification help
    By Clive S in forum Stepper & Servo Motors
    Replies: 3
    Last Post: 25-09-2013, 05:35 PM
  3. Motor Identification
    By Ricardoco in forum General Electronics
    Replies: 5
    Last Post: 14-05-2013, 08:27 PM
  4. PARAJUST VFD part identification
    By asto in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 28-04-2013, 09:08 PM
  5. Machine Identification - What Is This?
    By machineage in forum Milling Machines, Builds & Conversions
    Replies: 9
    Last Post: 18-02-2013, 12:36 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts